The m80i water cooler from Twin Heat is a high-performance cooling solution designed to keep your CPU running at optimal temperatures, even under heavy loads. Installing this cooler can be a bit daunting, but with the right guidance, it’s a straightforward process. In this comprehensive guide, we’ll walk you through the step-by-step installation process, ensuring you have all the necessary information to get your m80i up and running smoothly.
Preparing the Components
Before you begin the installation, make sure you have all the necessary components on hand. This includes the m80i water cooler, the back plate, thermal paste, and the mounting screws. If the cooler doesn’t come with pre-applied thermal paste, you’ll need to apply a small amount to the CPU’s surface. The amount of thermal paste required is typically a pea-sized drop or a thin, even spread across the CPU’s surface.
Installing the Back Plate
The first step in the installation process is to install the back plate. Locate the four holes on the back of the motherboard that correspond to your CPU type (in this case, Intel). From the front of the motherboard, push the back plate screws through these holes. The back plate should balance itself, but you can use four washers to secure it in place if needed.
Mounting the Water Block
Next, it’s time to mount the water block. Place the water block directly on the CPU, ensuring an even distribution of the thermal paste. Screw the water block into place using the four screws provided. As you tighten the screws, apply firm pressure to ensure proper thermal paste spreading and optimal contact between the water block and the CPU.
Connecting the Cables
With the water block in place, it’s time to connect the cables. Start by connecting the three-pin pump cable to the AIO pump header on your motherboard. If your m80i water cooler has RGB lighting, use the provided RGB splitter to connect the RGB connections to an ARGB header on your motherboard. Finally, connect any fan cables to the CPU header or a system fan header, using a fan splitter if necessary.
Installing the Radiator
The last step in the installation process is to install the radiator. Place the radiator on the case, ensuring it lines up with the screw holes on the top. Use the provided washers and screws to secure the radiator in place. To keep your setup clean and tidy, feed any dangling cables through to the back of the case.
Technical Specifications
The m80i water cooler from Twin Heat comes with the following technical specifications:
| Specification | Value |
|---|---|
| Radiator Size | 280mm |
| Radiator Thickness | 27mm |
| Fan Size | 140mm |
| Fan Speed | 500-1800 RPM |
| Fan Airflow | 97.8 CFM |
| Fan Noise Level | 12-30 dBA |
| Pump Flow Rate | 240 L/h |
| Pump Noise Level | 20 dBA |
| Tubing Length | 400mm |
For more detailed information, refer to the MANUAL FOR INSTALLATION – M20i • M40i • M80i provided by the manufacturer, Twin Heat.
Visual Guide
If you prefer a visual guide, check out the following video on how to install an AIO CPU liquid cooler in an LGA 1200 socket:
How to Install an AIO CPU Liquid Cooler in an LGA 1200 Socket
This video, while not specific to the m80i, provides a helpful overview of the general installation process for AIO liquid coolers.
Conclusion
Installing the m80i water cooler from Twin Heat may seem daunting at first, but with the right guidance and attention to detail, it’s a straightforward process. By following the steps outlined in this comprehensive guide, you’ll be able to set up your m80i water cooler and enjoy the benefits of improved CPU cooling performance. Remember to refer to the manufacturer’s manual and the visual guide for additional support throughout the installation process.
Reference: